Filter
Top Products
Using Your Remote
9
Note:
SET appears in the LCD for 20 seconds to indicate that the remote control
is ready to be programmed. The following steps must be entered while SET
appears in the LCD.
4.
Point the remote control toward the device that was turned on in Step 1
and enter in the first three-digit
Set-Up Code
number for that device
using the number buttons (0-9) on the remote control.
SET
followed by
the three-digit number will appear in the LCD.
Note:
If you have tried all of the three digit Set-Up Code numbers listed for your
device and it still did not turn off, please proceed to the Auto Search Method on
page 10 to program your remote control.
5.
Once your device turns off, press the
Device Button
selected in Step 3
once again to store the
Set-Up Code
number.
PASS
will flash in the
LCD.
6.
Test the remote control for your device. Try the
POWER, CHANNEL
UP AND DOWN, VOLUME UP AND DOWN
buttons, etc. If any of the
buttons do not perform as they should, please repeat the set-up from
Step 1 using the next
Set-Up Code
number for your device.
Note:
Some audio and video devices have separate buttons for POWER ON and
POWER OFF. To operate these devices on the remote, press the corresponding
Device Button to turn the equipment ON and press the POWER button to turn the
equipment OFF.
7.
Please repeat the above steps to program the remote control for each of
your other devices.