Filter
Top Products
Using Your Remote
14
Once you have stored the learned functions, test the buttons that have been taught.
If any of the buttons do not operate as they should, please repeat from Step 1 for
those buttons.
Note: If the LCD shows FAIL at any time during the learning process, the
AV7.1 was unable to learn the new functions. Please repeat from Step 4. If
the AV7.1 continues to show FAIL during the learning process, please try the
following suggestions:
• Increase or decrease the head to head distance between the two
remote controls, with a one to six inch range.
• Increase or decrease the time you press and hold the button on the
original remote control in Step 5, for one to two seconds.
• Avoid fluorescent lights or strong sunlight during the set-up. These
lighting conditions can cause interference with the learning
process.
• Verify that the original remote control contains fresh batteries.
Some remote controls operate at non-standard IR, UHF, or ultrasonic frequencies,
and are unable to be learned. If you continue to experience difficulty during set-
up, please contact the dealer you purchased your unit from or our customer service
department for assistance.
Learning New Functions on Device Buttons
The eight Device buttons at the top of the remote control can also learn new
functions.
These buttons can only be set up in the B&K mode
. If a new
functions is learned on a Device button, the new function will override and
existing preprogrammed information on the Device button.
1.
Place the AV7.1 and the original remote control to be learned from, on a
flat surface. Line up the remote controls head to head, approximately 2
to 3 inches apart.
2.
Press and hold both the
B&K
and
SEL / PLAY
buttons simultaneously,
for approximately three seconds, until the LCD on the AV7.1 shows
LEARN
. The AV7.1 is now in the learning mode.
3.
Press and release one of the eight Device buttons on the AV7.1. The
LCD will show
READY
.
Note:
Each of the following steps must be completed within 20 seconds. If the
remote does not receive any commands within the allotted time, it will return to its
normal operating mode.