Clarity WN-5040-720 CRT Television User Manual


 
10
2.2 Installing the VIM (Video Input Module)
It is easier to install the VIM board in Margays before they get stacked in a wall.
The Video Input Module option is installed in the
field.
You will install the VIM (Video Input Module) in the
Margay’s electronics module. (The electronics mod-
ule is the part the receives all the input and output
cables.)
If the electronics module is installed in the Mar-
gay, you will remove it partially.
1. Turn off the AC power to the Margay and remove
the power cord.
2. Open the door on the right side of Margay (as
viewed from the front) exposing the electronics
module.
3. Loosen the two screws at the top of the electronics
module.
4. Pull the module up and partly out.
a. It may take a bit of maneuvering to get the con-
nectors at the bottom to come up with the
module.
b. Do this carefully so you do not damage the con-
nectors. All connectors are latched in place.
They aren’t particularly delicate, but they won’t
stand very rough treatment.
5. Install the VIM in the electronics module.