Filter
Top Products
Page 57
Using the Remote Controls
3. If you see the System Info screen, press the SELECT button to close the
screen. You have recovered your satellite video.
4. If you do not see the
System Info screen, repeat steps 2 and 3 until you
have recovered your satellite video.
Note: Press any remote control button other than the RECOVER button to
end this procedure.
Note: If the RECOVER button is not programmed to a specific channel,
the RECOVER button will first try to tune your TV to channel 3, then
channel 4, and then other video inputs with each press of the RECOVER
button. You may need to press the RECOVER button up to 30 times to
recover your satellite TV video. If the RECOVER button is programmed to
a specific channel (see page 25), the RECOVER button will tune the TV to
the specific channel (for example, channel 60).
DVR Buttons
Use these buttons to record or play back a DVR program. See Using the DVR
Features on page 85 for details.
PIP Button
Press the PIP button to open the PIP window. To make the PIP window larger,
press this button again. Press the button a third time to close the
PIP window.
This button is active only in
Single Mode.
Swap Button
Press the SWAP button to swap the video in the main display with the video in
the
PIP window. This button is active only in Single Mode.
Position Button
Press the POSITION button to move the PIP window to different positions on
the TV screen. Each press of this button move the
PIP window. This button is
active only in
Single Mode.