Filter
Top Products
Installation
Section 3
Digital Satellite Receiver Page 3 - 1
© 2002 EchoStar International Corporation
All rights reserved
3
INSTALLATION
1. CONNECT YOUR EQUIPMENT
It is possible to connect the different equipment with the use of UHF coaxial cables,
SCART cables, and/or so called audio/video cables with RCA connectors.
CONNECTION WITH UHF COAXIAL CABLES
1. On the TV, find the UHF-coaxial cable that is connected to the terrestrial antenna or cable
network.
2. Remove the UHF-coaxial cable from the TV and make sure the cable condition is OK.
3. On the rear panel of the receiver find the TV OUT connector.
4. Install an UHF-coaxial cable between the TV OUT connector (receiver) and the antenna
connector (TV).
5. On the rear panel of the receiver find the ANT IN connector.
6. Install the UHF-connector (terrestrial antenna) to the ANT IN connector (receiver).
CONNECTION WITH SCART CABLES
1. On the TV find the SCART cable that is connected to the VCR.
2. Remove the SCART connector that is connected to the VCR from the TV.
3. On the rear panel of the receiver find the DECODER, TV and VCR SCART connectors.
4. Install a full featured SCART cable between the decoder and the DECODER SCART
connector (receiver).
5. Install a full featured SCART cable between the VCR and the VIDEO SCART connector
(receiver).
6. Install a full featured SCART cable between the TV SCART connector (receiver) and the
SCART connector on the TV (old SCART connection to the VCR).
CONNECTION WITH AUDIO/VIDEO CABLE (RCA-CONNECTORS)
1. On the rear panel of the receiver find the VIDEO, AUDIO L and AUDIO R connectors.
2. Install an audio/video cable between:
a. the VIDEO connector of the receiver and TV (yellow);
b. the AUDIO L connector of the receiver and TV (white);
c. the AUDIO R connector of the receiver and TV (red).
CONNECTION WITH DOLBY DIGITAL AUDIO CABLE (RCA-CONNECTORS)
1. On the rear panel of the receiver find the S/PDIF connector.
2. Install an audio/video cable (black) between:
a. the S/PDIF connector (receiver) and Dolby Digital connection of the Dolby digital
compatible installation.
CONNECTION WITH SERIAL CABLE (0-MODEM CABLE)
1. On the rear panel of the receiver find the SERIAL PORT connector.
2. Install a serial cable between the SERIAL PORT connector (receiver) and the serial port
connection of the PC.
CONNECTION WITH USB CABLE
1. On the rear panel of the receiver find the USB connector.
2. Install a serial cable between the USB connector (receiver) and the USB connection of
the PC.
WARNING
ALL EQUIPMENT INVOLVED IN THE INSTALLATION TASK MUST BE INSTALLED CORRECTLY
ANDSWITCHEDOFF
.MAKE SURE THAT IT IS SAFE TO PROCEED WITH THE INSTALLATION
TASK
.UNSAFE CIRCUITS AND INSTALLATIONS CAN CAUSE (SERIOUS) INJURY OR DAMAGE
TO EQUIPMENT
.