Filter
Top Products
Installation
Section 3
Digital Satellite Receiver Page 3 - 5
© 2002 EchoStar International Corporation
All rights reserved
3
FOR FIXED AND DISEQC1..4SWITCH INSTALLATIONS
NOTE
The receiver needs the correct local time to collect and show the EPG (Electronic
Program Guide). An incorrectly entered local time will result in no EPG information.
15. Make the required selections.
16. Read the available help text for information.
17. On the RCU, use thekeys to select.
18. Go to the Press OK to set the time.
Note that the local time is shown correctly.
19. On the RCU, press the OK key to advance.
20. Go to the Continue field.
21. On the RCU, press the OK key to advance.
NOTE
From the next step onwards, the procedure is divided in different configurations.
The configurations are; Fixed, Motorized and SMATV.
■ Fixed means set up either a single dish, multiple dishes with DiSEqC switch;
■ Motorized means set up a moveable dish (motor/actuator by positioner);
■ SMATV means set up for television distribution (cable network in buildings).
22. Make the required selections.
23. Read the available help text for information.
Note that only the white fields are selectable,
other fields show reference information.
24. Go to the Check Signal field.
25. On the RCU, press the OK key to advance.
26. Wait for the Checking Configuration to complete.
27. Make the required selections.
28. Read the available help text for information.
29. If the red dot in the transponder field stays:
a. select another transponder;
b. go to the check signal field;
c. on the RCU, press the OK key.
30. Go to the Search Channels field.
31. On the RCU, press the OK key to advance.