Filter
Top Products
Installation
Section 3
Digital Satellite Receiver Page 3 - 3
© 2002 EchoStar International Corporation
All rights reserved
3
FIXED DISH INSTALLATION WITH DISEQC SWITCH
3. Install the F-connector (DiSEqC switch) to the LNB IN connector (receiver).
4. Install the delivered loop through cable between the IF OUT connector (receiver) to the
LNB IN ANALOG connector (receiver).
MOTORIZED DISH INSTALLATION WITH LNB(F)
1. On the dish installation (for detailed instructions refer to the manufacturer’s instructions):
a. connect a RF cable;
b. connect the power and sensor cables;
c. if present, set the East and West limit switches to prevent dish damage.
2. On the rear panel of the receiver find:
a. the LNB IN (digital), the IF OUT and the LNB IN ANALOG, connectors;
b. the M.PULSE,theGND,theM1 and the M2 connectors.
3. Install the F-connector (dish) to the LNB IN connector (receiver).
4. Install the delivered loop through cable between the IF OUT connector (receiver) to the
LNB IN ANALOG connector (receiver).
5. On the rear panel of the receiver find the M.PULSE,theGND,theM1 and M2 connectors.
6. First install the motor sensor cables to the M.PULSE and GND connector (receiver).
7. Install the motor power cable to the M1 and M2 connectors (receiver).
DISH INSTALLATION WITH FERRITE FEED
1. On the dish installation, connect the ferrite cables (for detailed instructions refer to the
manufacturer’s instructions).
2. On the rear panel of the receiver find the Ferrite + and the Ferrite - connectors.
3. Install the ferrite power cable to the Ferrite + and Ferrite - connectors (receiver).
DISH INSTALLATION WITH POLAROTOR
1. On the dish installation, connect the polarotor cables (for detailed instructions refer to the
manufacturer’s instructions).
2. On the rear panel of the receiver find the +5V,theGND and the SKEW connectors.
3. Install the polarotor power cable to the +5Vand GND connectors (receiver).
4. Install the polarotor skew cable to the SKEW connector (receiver).
CAUTION
It is possible that the GND connector is already occupied by the motor sensor
cable. If you need to connect the GND for the polarotor as well, please use the
appropriate connection materials to connect both cables. Failing to do so can
cause damage to the equipment.