Filter
Top Products
Maintenance
Section 6
Digital Satellite Receiver Page 6 - 1
© 2002 EchoStar International Corporation
All rights reserved
6
MAINTENANCE
1. HARDWARE MAINTENANCE
1. Switch the receiver to stand-by and on the display make sure the clock shows.
2. Remove the mains plug from the power supply socket.
3. Wait at least five seconds, to help avoid possible damage to the receiver’s electronics.
4. Use a dry, soft and clean lint-free cleaning cloth to clean the receiver.
5. Other cleaning agents can cause damage to the outside surface.
a. Make a dry, soft and clean lint-free cleaning cloth a little damp.
b. Carefully wipe the surface and make sure that no moisture gets into the receiver.
c. Let the receiver dry on the air.
6. Install the receiver and make sure all connections on the rear panel are made correctly
(For more detailed instructions, please refer to the section Installation).
7. Connect the mains plug to the power supply socket.
8. Set the local time, for detailed instructions please refer to the section Operation.
2. SOFTWARE MAINTENANCE
2.1. TO CHANGE THE SETUP OF THE RECEIVER
WARNING
RISK OF ELECTRICAL SHOCK.
R
EMOVE THE MAINS PLUG FROM THE POWER SUPPLY SOCKET BEFORE YOU CLEAN THE
RECEIVER
.MAKE SURE, IF USED, CLEANING AGENTS CANNOT GET IN THE RECEIVER.
NOTE
Make sure the local time is set correctly otherwise you can not view and use the
EPG information because the EPG and the related timers need the correct time.
NOTE
Unless otherwise specified; This note explains the way you can navigate through
the maintenance pages of the EchoNAV setup menu.
1. Use the OK key to pull down the menu selection fields.
2. Use the
arrow keys to go through the selectable menu items.
3. In a pull-down menu, use the OK key to confirm the selection.
4. Use the
arrow keys to navigate between the left and right column of
selectable menu items.
5. Use the EXIT key to leave the menu and return to the live mode.
1. On the RCU, press:
a. the MENU key;
b. the key to select the menu;
c. the OK key, to select the or menu.
2. Press the OK key and make the selections.
3. Read the available help text for information.
4. Go to the Check Signal field.
5. On the RCU, press the OK key.