Filter
Top Products
Section 4
Familiarization
Page 4 - 10 EchoStar DVR-7000 Viaccess
© 2002 EchoStar International Corporation
All rights reserved
2.2.2. FIXED DISH SETUP
This sub menu allows you to customize the system setup to add an additional fixed dish into
your motorized configuration. Note that the menu page is dynamic which means that it
changes with the selections you make. You can customize:
2.2.3. PROGRAM SATELLITES
This sub menu allows you to customize the system setup to add an additional satellite into
your receiver. Note that the menu page is dynamic which means that it changes with the
selections you make. You can customize and view:
■ LNBs
To set the amount of LNBs you have installed.
■ Polarity
To set the device that controls the signal polarity.
■ Switch
To set the switch type which you use to control the
dish installation.
■ LNB1
To set the LNB type(s) you use.
■ Satellite
To set the satellite you want to scan for the LNB.
■ Check Signal
To confirm the selections you made and advance
to the Check Signal page.
■ Satellite
To set the satellite you want to scan for the LNB.
■ Search mode
To set a specific search mode (All, FTA, IF, TP,
network or update).
■ Longitude
To view the satellite location on the Clarke Belt.
■ Transponder
To select a transponder of the selected satellite.
■ Skew
To adjust the Horizontal/Vertical setting (only for
polarotor).
■ Location
To move the dish for best signal level and quality.
■ Satellite offset
To compensate for a dish offset caused by ambient
conditions.
NOTE
The satellite offset will affect all satellite positions,
this means that all scanned positions will change
which might result in total loss of signal for all
satellites.
■ Search Channels
To confirm the selections you made and advance
to the Search Channels page.