Filter
Top Products
Initial Calibration
This section describes:
How to Access the Internal On-screen Menus
The Main, Volume, Time, Network, and Video Screens
The Screen Touch Calibration Screen
How to Access the Internal On-screen Menus
When power is first applied to the TouchLink Panel, the unit boots up and displays the
opening screen. To access the on-screen menus, press the Menu button, which is located
below the screen (see page 5 for the TLP 700MV or page 8 for the TLP 700TV).
The menus open at the Main screen. There are five different screens (Main, Volume,
Time, Network, and Video) that can be selected by pressing the appropriate button at
the left side of the screen.
There is also an Exit button at the bottom left corner of the screen for leaving the
menus.
Main Screen
The Sleep timer determines how long the panel is inactive before it enters Sleep mode,
when the screen goes dark to save power. Press the Down or Up buttons to highlight
the Sleep timer options and continue to use the buttons or use the volume control knob
to adjust the time from 0 to 50,000 seconds (in 10-second increments). The time that is
currently selected is shown above the buttons.
The screen may need a high level of backlighting to read the screen when ambient lighting
is high. With low ambient lighting, the backlighting should be low.
Auto Backlight provides a suitable amount of backlighting that is automatically calculated
from the amount of ambient light detected by the light detector.
TLP 700MV and TLP 700TV • Initial Calibration 11