Filter
Top Products
0150-0193C 40 Calibur DVMR
e
Triplex
q Main Menu → Alarms → Relay Configuration
Use this menu to configure each relay output as either:
• Normally Open
• Normally Closed
q Main Menu → Alarms → Buzzer Setup
Use this menu to configure the internal buzzer.
Global Buzzer: The Global Buzzer setting acts as a master On/Off
switch. Setting the Global Buzzer to OFF deactivates all buzzer
activity.
Live Alarm Buzzer: Activates while receiving alarm input.
Videoloss Buzzer: Activates when video loss is detected.
Disabling the Videoloss buzzer disables all videoloss buzzer activity.
Videoloss buzzers may be disabled on a per camera basis in the
Alarms → Videoloss Action menu.
Playback Buzzer: Activates during playback of recorded alarms.
q Main Menu → Alarms → Videoloss Action
Use this menu to configure how the unit responds to videoloss.
Camera: Select the camera you wish to configure.
Relay 1: If enabled, the unit will activate Relay 1 when videoloss
is detected.
Relay 2: If enabled, the unit will activate Relay 2 when videoloss is
detected.
Buzzer: Use this setting to disable the videoloss buzzer activation
on a per camera basis. To disable videoloss buzzer activation on
all cameras go to the Main Menu → Alarms → Buzzer Setup menu,
described in the previous section.
q Main Menu → Alarms → Pre Alarm Duration
During recording, the unit stores up to 5 seconds of recorded
information in a buffer. This data can be automatically retrieved when
an alarm is activated. Select the amount of time just previous to the
activation of an alarm you wish to retrieve.
q Main Menu → Alarms → Notification
Use this menu to select:
• Email Alarm Notification.
• TCP/IP Dialout Notification.
Relay Configuration
[CANCEL] [OK]
Relay 01:
Relay 02: N/CLOSED
N/OPEN
Buzzer Setup
[CANCEL] [OK]
Global Buzzer :
Live Alarm Buzzer: ON
Videoloss Buzzer : ON
Playback Buzzer : ON
ON
Videoloss Action
[CANCEL] [OK]
Camera :
Relay 1: Disable
Relay 2: Enable
Buzzer : Enable
01
Pre Alarm Duration
05
(Time in Seconds)
TCP/IP Dialout
Email