Hitachi 42EDT41A Flat Panel Television User Manual


 
26
G
U
I
D
E
A
/V N
ET
THE REMOTE CONTROL
HOW TO USE THE REMOTE
TO CONTROL YOUR PLASMA MONITOR
CHANNEL SELECTOR buttons
The CHANNEL SELECTOR buttons are used to select channels, lock access code, etc. Use the CHANNEL SELECTOR buttons
to enter one, two or three numbers to select channels. Enter “0” first for channels 1 to 9, or simply press the single digit channel
you wish to tune then wait for a few seconds for the TV to tune. Enter “1” first for channels 100 and above, wait for a few seconds
till the 3 digit channel display icon appears then press the next 2 digits to completely tune the channel.
VIDEO (AV1 to AV4) / RGB (RGB1 and RGB2) buttons
Press these buttons to directly access the desired Input.
C.C / TEXT buttons
Press these buttons to directly change the Captions Mode to Captions and Text.
Vertical picture position can be adjusted for [Panoramic], [Zoom] and [Cinema] mode as follows.
1. Press ZOOM button and ̆,̄ SELECT buttons during picture size display.
2. Position display will appear.
3. Adjustment range of each picture size are as shown below.
[Panoramic] - 12 to + 12
[Zoom] and [Cinema] - 31 to + 31
4. When 1080i/50 or 1080i/60 component signal is received, vertical position can be adjusted only one step up. (The range: 0 to +1)
USING A WIDE-SCREEN MONITOR
NOTES: 1. This monitor has a screen mode selection feature. If an incompatible screen mode is selected to play certain software,
such as a TV program,the image would appear different from the original. Take this into consideration when making
screen mode choices.
2. Use of this monitor in its enlarged display mode with the wide feature enabled in coffee shops, hotels and other
establishments for commercial or pubic viewing purposes could infringe on the copyright holder’s right protected by
Copyright Law.
3. When a normal 4:3 image is displayed over the entire screen in the Panoramic mode, parts of the periphery of the
image may disappear and/or appear distorted in some cases. Use the 4:3 mode to view images, which were created
in 4:3 mode. This mode allows 4:3 content to be viewed without picture distortion.
Press
Position + 31
Position - 31
Press