Hitachi 42EDT41A Flat Panel Television User Manual


 
Securing to a table-top
1. Using wood screws (two) fasten the set to the clamping screw holes on the rear of the Plasma Television stand as shown below.
2. Using commercially available wood screws, secure the set firmly in position.
HOW TO SETUP YOUR NEW HITACHI
PLASMA DISPLAY TELEVISION
5
To take measures to prevent the Plasma Television from tipping over and prevent possible injury it is important to mount the
unit in a stable place.
Caution when moving the main unit
As this product is heavy, whenever it is moved, two people are required to transport it safely. Whenever the unit is moved it should be
lifted forward using the two handgrips at the back for the plasma television. When moving the Display Monitor, lift the handles and the
bottom frame as shown below. Do not grab the speakers or the back cover when lifting.
Securing to a wall or pillar.
Using a commercially available cord, chain and clamp, secure the set to a firm wall or pillar.
NOTES: 1.
Do not block the ventilation holes of the Plasma Television. Blocking the ventilation holes might cause fire or defect.
2. The plasma display has one AC cord. In case of an abnormal symptom, unplug the AC cord.
3. If you purchased the wall mount bracket option, please ask for professional installer. Do not install by yourself.
Handgrips
30 cm (12 inches)
10 cm (4 inches)
10 cm (4 inches)
ANTENNA
Unless your Plasma Television is connected to a cable TV system or to a centralized antenna system, a good outdoor color TV antenna
is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference
and multiple image ghosts, an indoor antenna may be sufficient.
LOCATION
Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. Also, be sure that the location
selected allows a free flow of air to and from the perforated back cover of the set. In order to prevent an internal temperature increase,
maintain a space of 10 cm (4 inches) from the sides/back of the monitor, and 30 cm (12 inches) from the top of the television to the wall.
To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the TV where temperatures can
become excessively hot, for example, in direct sunlight or near a heating appliance, etc.
Wood screw
two places
Hook
Chain
cord or chain
clamp
Wall or Pillar
10cm (4 inches) or more
FIRST TIME USE