Filter
Top Products
29
G
U
I
D
E
A/
V
N
E
T
THE REMOTE CONTROL
MULTI PICTURE (PinP)
Activating the P-in-P mode from the RGB input screen
Pressing the PinP button one time will display 2 pictures.
• This mode can be available from RGB1(DVI-PC) and RGB2(RGB) Input.
• The speaker icon can be shifted up and down by pressing the A/B button; the audio of the video
will be output from the side on which the speaker icon is located.
• The sub-screen position can be selected up and down by pressing ̆ and ̄ SELECT buttons.
• The sub-screen can be selected with the AV1, AV2, AV3, AV4 and TV channel number buttons
from the status that the speaker icon appears on the left side of AV* as shown in the diagram
to the right.
• Pressing the PinP button again or the RETURN button will cancel the 2 pictures display.
• "Frequency Mode" in the Setup Menu should be set to Movie when sub-screen is the
component signal of 1080i/50 or 1080i/60.
AV1: Displays the VIDEO input signal of the sub-screen.
Displaying MULTI PICTURE
If the PinP button on the remote control is pressed MULTI PICTURE will display.
5AV1
RGB2
AV1
(Sub-
screen)
Activating the Split mode from the video input screen
Pressing the PinP button one time will display 2 pictures.
• The speaker icon can be shifted left and right by pressing the A/B button; the audio of the video
will be output from the side on which the speaker icon is located.
• The same video input mode cannot be selected for both screens at the same time.
• Pressing the PinP button again or the RETURN button will cancel the 2 pictures display.
• When the Video input is set to RGB Video, this Split mode is not possible.
• Refer to the table for 2 pictures (Split) mode.
5AV1
AV1 AV2
PinP button
RETURN button
RECALL button
A/B button
SELECT button