Filter
Top Products
Filename [DR-M10AG_AX_AA2_08Recording.fm]
Masterpage:Left+
52 EN
Page 52 April 27, 2004 11:03 am
TIMER RECORDING (cont.)
G-CODE
TM
/
S
HOWVIEW
TM
Timer
Programming
You can programme this unit to timer-record as many as
8 programmes.
With the G-
CODE system, timer programming is greatly
simplified because each TV programme has a corresponding
code number which your unit is able to recognize.
You can use the remote control to enter the G-
CODE number.
A
Load a disc.
A Press x to open the disc tray.
B Place a recordable disc on the disc tray.
● For details, refer to “Placing a Disc” (੬ pg. 9).
C Press x to close the disc tray.
B
Access the G-CODE screen.
Press G-CODE/SHOWVIEW.
C
Enter the G-CODE number.
● To clear all entered numbers at a time, press 8.
● If the number you entered is invalid, “G-CODE/SHOWVIEW
NO. ERROR CONFIRM G-CODE/SHOWVIEW NO. THEN
RETRY” appears on the TV screen. Input a valid G-
CODE
number.
● If “GUIDE PROGRAMME IS NOT SET SELECT CHANNEL
YOU WANT TO RECORD” appears on the TV screen, set
Guide Program Numbers (
੬ pg. 51) manually.
● When “PROGRAMME FULL DELETE UNWANTED TIMER
PROGRAMME” appears on the TV screen, you need to cancel
some of the reserved programmes. (
੬ pg. 59)
D
Check the programme data.
The G-CODE number you entered and the matching timer-
recording information are displayed on the TV screen.
Check if they are correct.
● To cancel this setting, press G-CODE/SHOWVIEW or
RETURN.
INFORMATION
G-CODE and SHOWVIEW are different trademarks used to
represent the same easy recording feature, but only the term
G-
CODE system will be used in the instructions. If you use the
S
HOWVIEW system, follow the same instructions listed for the
G-
CODE system.
DVDTV
DVD
TIMER
PROG/CHECK
NEXTPREVIOUS
PAUSEREC
REC MODE LIVE CHECK
SET UP DISPLAY
ON SCREEN
OPEN/
CLOSE
AUDIO SUBTITLE ANGLE
PROGRESSIVE
SCAN
SLOWSLOW PLAY/SELECT
STOP/
CLEAR
NAVIGATIONTOP MENU
RETURN
ENTER
MENU
STANDBY/ON
ABC
JKLGHI MNO
TUVPQRS WXYZ
AUXCANCEL
MEMO/MARK
DEF
CH
REC LINK
G-CODE
SHOW VIEW
TV
TV
MUTING
TV/
VIDEO
TV VOLUME
rtwe
ENTER
8
x
#
0 – 9
RETURN
G-CODE/
SHOWVIEW
&
DVDTV
Before performing the G-CODE Timer Programming:
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/DVD switch to DVD.
● Make sure that the unit’s built-in clock is set
properly.
● Be sure to read “G-
CODE
TM
/SHOWVIEW
TM
System Setup”
on page 51
Press the number keys to
enter the G-
CODE number of
a programme you wish to
record, then press ENTER.
● If you have made a mistake,
press & and input the correct
number before you press
ENTER.
IMP
O
RTANT:
Make sure the channel position number you wish to record is
displayed; if not, see “G-
CODE
TM
/SHOWVIEW
TM
System Setup” on
page 51 and set the Guide Program number correctly.