Filter
Top Products
Filename [DR-M10AG_AX_AA2_10Editing.fm]
Masterpage:Left+
86 EN
Page 86 April 27, 2004 11:10 am
SYSTEM CONNECTIONS (cont.)
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
These instructions enable you to connect your unit to a Dolby Digital decoder or an amplifier with built-in DTS.
Make connections.
Connect the unit and a Dolby Digital decoder or an
amplifier with built-in DTS using either an optional
optical cable or an optional coaxial cable.
NOTES:
● For Dolby Digital sound, set “DIGITAL AUDIO OUT” to
“DOLBY DIGITAL/PCM”. (
੬ pg. 88)
● For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/
PCM”. (
੬ pg. 88)
CAUTIONS:
● This unit has a dynamic range of more than 110 dB with
regards to its Hi-Fi audio capability. It is recommended that
you check the maximum level if you are going to listen to the
Hi-Fi audio signals through a stereo amplifier. A sudden surge
in the input level to the speakers may damage them.
● Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the playback picture.
Back of unit
Note for connection:
Remove the protection
cap from the optical
cable.
Optical cable
(not provided)
Dolby Digital
decoder or amplifier
with built-in DTS
To DIGITAL AUDIO
input
Coaxial cable
(not provided)
DIGITAL OUT
(OPTICAL)
DIGITAL OUT
(COAXIAL)
When you can’t switch the audio channel of a
bilingual programme
When the unit is connected with a digital audio device using
an optional optical cable and “DIGITAL AUDIO OUT” is set
to “DOLBY DIGITAL/PCM”, it is not possible to switch the
audio channel of a bilingual programme recorded on a
DVD-RAM or DVD-RW (VR mode) disc. In this case, perform
the following steps using the remote control to switch
“DIGITAL AUDIO OUT” from “DOLBY DIGITAL/PCM” to
“PCM ONLY”.
A Press SET UP to access the Main Menu screen.
B Press we to select “DVD SET UP”, then press ENTER.
C Press we to select “AUDIO OUTPUT”, then press
ENTER.
D Press rt to select “DIGITAL AUDIO OUT”, then press
ENTER.
E Press rt to select “PCM ONLY”, then press ENTER.
(
੬ pg. 88)
F Press SET UP to complete the setting.
G Press AUDIO to select the desired audio channel.
(
੬ pg. 30, “Audio Channel Selection”)
DR-M10SAG_AX_AA2_01.book Page 86 Thursday, May 6, 2004 10:46 AM