Filter
Top Products
Masterpage:Right0
EN 83
Filename [DR-M10AG_AX_AA2_10Editing.fm]
Page 83 April 27, 2004 11:10 am
REMOTE CONTROL
Remote Control
Functions
Remote 1/2/3/4 Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of four
codes (1, 2, 3 or 4). The remote control is preset to send 3 code
signals because your unit is initially set to respond to 3 code
signals. You can easily modify your unit to respond to 2, 3 or 4
code signals.
On the remote control
Keep pressing SET UP down during steps A – B.
A
Change the remote control code.
Press the number key “1” for 1, “2” for 2, “3” for 3 or
“4” for 4.
B
Set the remote control code.
Press ENTER to set the code.
On the unit
C
Turn off the unit.
Press 1 on the unit.
D
Display the code.
Press 4 on the unit for over 5 seconds while the unit is
turned off.
● The code currently set appears on the front display panel.
E
Change the unit’s code.
Press 8 on the remote control.
● The code currently set on the remote control blinks on the
front display panel for approximately 5 seconds, and is
applied to the unit.
NOTE:
When “POWER SAVE” is set to “ON” (੬ pg. 90), it is not
possible to change the remote code.
Slide the TV/DVD switch to DVD.
1
STANDBY/ON
S-VIDEO VIDEO
L(MONO)
-
AUDIO
-
R
DV
DV IN
F1
REC MODE
REC
LINK
PULL - OPEN
1
4
DVDTV
DVD
TIMER
PROG/CHECK
NEXTPREVIOUS
PAUSEREC
REC MODE LIVE CHECK
SET UP DISPLAY
ON SCREEN
OPEN/
CLOSE
AUDIO SUBTITLE ANGLE
PROGRESSIVE
SCAN
SLOWSLOW PLAY/SELECT
STOP/
CLEAR
NAVIGATIONTOP MENU
RETURN
ENTER
MENU
STANDBY/ON
ABC
JKLGHI MNO
TUVPQRS WXYZ
AUXCANCEL
MEMO/MARK
DEF
CH
REC LINK
G-CODE
SHOW VIEW
TV
TV
MUTING
TV/
VIDEO
TV VOLUME
DVD F
ENTER
SET UP
8
1 – 4
DVDTV
DR-M10SAG_AX_AA2_01.book Page 83 Thursday, May 6, 2004 10:46 AM