Filter
Top Products
Masterpage:Right-No-Heading
EN 81
Filename [DR-M10AG_AX_AA2_10Editing.fm]
Page 81 May 7, 2004 2:42 pm
D
Return to the normal screen.
Press SET UP.
L-2 Select Setting (L-2 SELECT)
Set “L-2 SELECT” to the appropriate mode depending on the
type of appliance connected to the unit’s L-2 IN connector.
NOTE:
When you connect the unit using the provided cable adapter, be
sure to set “L-2 SELECT” to “VIDEO”. If “L-1 INPUT” is set to
other than “VIDEO”, the image may be distorted.
A
Select the input mode for the L-2 IN
connector.
(The boldface settings in the table below indicate the settings at
your purchase.)
B
Return to the normal screen.
Press SET UP.
F-1 Input Setting (F-1 INPUT)
Set “F-1 INPUT” to the appropriate mode depending on the
connector (VIDEO or S-VIDEO) being used on the front panel.
A
Select the input mode for the VIDEO/
S-VIDEO connector.
(The boldface settings in the table below indicate the settings at
your purchase.)
B
Return to the normal screen.
Press SET UP.
Perform steps A and B of “L-1 Output and L-1 Input Setting
(L-1 OUTPUT and L-1 INPUT)” on page 80.
A Press rt to move the
arrow to “L-2 SELECT”,
then press ENTER.
B Press rt to select the
appropriate setting, then
press ENTER.
8 L-2 SELECT
Select “VIDEO” to use this unit as the recording deck with
the player connected to the L-2 IN connector, or to use the
satellite receiver connected to the L-2 IN connector.
VIDEO: If a connected appliance’s output is
compatible only with regular video
signals, set to “VIDEO”.
S-VIDEO*: If a connected appliance’s output is
compatible with Y/C signals, set to
“S-VIDEO”. (For connection, be sure
to use a 21-pin SCART cable that is
compatible with the Y/C signal.)
SAT VIDEO**: If a connected satellite receiver’s
output is compatible only with
regular video signals, set to “SAT
VIDEO”.
SAT S-VIDEO**: If a connected satellite receiver’s
output is compatible with Y/C
signals, set to “SAT S-VIDEO”.
(For connection, be sure to use a
21-pin SCART cable that is
compatible with the Y/C signal.)
* These settings are not correctly operative when using the
provided cable adapter.
** These settings are not available with this unit.
Perform steps A and B of “L-1 Output and L-1 Input Setting
(L-1 OUTPUT and L-1 INPUT)” on page 80.
A Press rt to move the
arrow to “F-1 INPUT”,
then press ENTER.
B Press rt to select the
appropriate setting, then
press ENTER.
8 F-1 INPUT
VIDEO: When connecting an appliance to
the VIDEO input connector, set to
“VIDEO”.
S-VIDEO: When connecting an appliance to
the S-VIDEO input connector, set to
“S-VIDEO”.