Filter
Top Products
20
Connection and setup
The following display appears:
Satellite Conguration - Tuner 1
Make the settings for the rst satellite for tuner 1 here.
LNB Type:
If your reception system does not have a Universal LNB, use the
buttons to select the LNB types that are used in
your reception system. You can choose from the following LNB types:
- Universal
- Simple or
- User-dened
LNB frequency (MHz):
You only need to specify this data if your LNB type is not “Universal LNB”. The data required differ for the settings
“Simple” and “User-dened”. Refer to the documentation supplied for your LNB.
- Selection “Simple” LNB: Use the numeric keypad to enter the LNB frequency
- Selection “User-defined”: Press the
button to input the required low, high and limit frequencies as necessary.
The input is performed using the numeric keypad
DiSEqC™ Input:
- 1 of 4: For the rst satellite on the tuner (item A on the system)
- 2 of 4: For the second satellite on the tuner (item B on the system)
- 3 of 4: For the third satellite on the tuner (item C on the system)
- 4 of 4: For the fourth satellite on the tuner (item D on the system)
DiSEqC™ Repeat:
The setting for how often the DiSEqC™ command must be repeated depends on the conguration of your reception
system. Refer to the documentation for your reception system or seek assistance from a specialist engineer.
- Off DiSEqC™ command is not repeated
- 1 DiSEqC™ command is repeated once
- 2 DiSEqC™ command is repeated twice or
- 3 DiSEqC™ command is repeated three times