Filter
Top Products
103
Search with service ID
Main menu - Channel search
Symbol Rate
Use the numeric keypad to enter the relevant symbol rate.
Channel search mode
Use the
buttons to select the type of channels that are to be searched for. You have three options:
- “free & scrambled” All channels are searched for
- “only free” Only free-to-air channels are searched for
- “only scrambled” Only encrypted channels are searched for
To view encrypted channels you need an appropriate CA (Conditional Access) module and a valid smart card
together with a valid subscription to the relevant Pay TV provider.
Network Search
Use the
buttons (On/Off) to select whether a network search should be performed. If you set the network
search to “Off”, only the factory default transponders for the satellite(s) you previously selected will be searched
for new as yet unsaved channels. If you set the network search to “On”, the transponder network enables additional
transponders that have not yet been stored to be located. They are then stored and searched for new channels in the
same way as the existing transponders. Once you have made all the settings, use the
buttons to switch to the
“Start search” eld and conrm the start of the search using the
button.
After calling up the menu you will see the following
display:
The
buttons allow you to select different sets
of parameters for the search.
Satellite
Use the
buttons to select the satellite that is transmitting the channels to be searched. By pressing the
button
at this point you can view a list of the installed satellites. Use the
buttons to select the satellite you want and conrm
your selection with the
button. Make sure your reception system is aligned to this/these selected satellite(s).