Filter
Top Products
42
Connection and setup
Network Search
Use the
buttons (On/Off) to select whether a network search should be performed. If you set the network
search to “Off”, only the factory default transponders for the satellite(s) you previously selected will be searched
for new as yet unsaved channels. If you set the network search to “On”, the transponder network enables additional
transponders that have not yet been stored to be located. They are then stored and searched for new channels in the
same way as the existing transponders.
When you have completed all settings, press the
(green) button. The following displays appear (example):
During the search you will see the following display
(example):
New channels found are identied by the sufx “NEW”
(see screenshot example, right).
TV channels
found
Radio channels
found
After completion of the search, you will see the following
display (example):
Press the
button. The new channels founded are
added at the end of the existing complete list.
Note:
You can cancel the search at any time by pressing the
button.