Filter
Top Products
21
Connection and setup
22 kHz signal:
You only need to specify this data if your LNB type is “Simple”. The 22 kHz signal is needed to switch LNBs in multi-feed
reception and to switch between Low and High band.
- On
- Off
Test-Transponder:
Select the “Test-Transponder” eld. Here you can select a transponder for checking whether your settings are correct
using the signal strength bar and signal quality bar.
When you have completed all settings for this satellite, press the
(green) button.
If you have selected more than one satellite (max. four) for tuner 1, the receiver will automatically skip to the settings for
the second satellite. Now make the settings for the second satellite, followed by the third and fourth satellites as required,
in the same way as described for the rst satellite.
Once all settings for all the satellites that you selected have been completed, the receiver will automatically skip to the
settings for the second tuner (assuming that for the second tuner you selected the connection type “Separated” and
set the signal conguration to “Different from Tuner 1”). If this is the case, now make the settings for the second tuner
in the same way as you did for the rst tuner.
Once you have completed the settings for both tuners and the satellites assigned to them, the receiver will automatically
display the screen for the channel search. Continue the rst installation with the “Channel search” chapter.
The individual items are selected using the
buttons. If you require to access submenus, they can be called up
using the
button. Changes to the current settings can be made using the
buttons or the numeric keypad.
DiSEqC™1.1
Press the
(green) button.