Filter
Top Products
6
Information on Audio MPEG Inc. and S.I.SV.EL, S.P.A:
This unit makes use of legally protected technologies, which are protected by patents in the USA and also by other
intellectual property rights in other countries.
KATHREIN-Werke KG has obtained licences from Audio MPEG Inc. and Societa‘ Italiana per lo sviluppo dell‘elettronica,
S.I.SV.EL, S.P.A to use these technologies. These licences carry certain restrictions, which apply also to you as the
customer. Accordingly this unit may only be used by the end customer for private non-commercial purposes and for the
licensed content. It may not be used for commercial purposes. The use of products or processes that are sold or used
with this unit is not included in this statement. The use of reverse engineering is not permitted in respect of the licensed
technologies, nor is disassembly.
The information in this operating manual was correct at the time of going to print. However, we reserve the right to make
changes at any time and without prior notice. If new software is released for your receiver, and this affects the information
in the operating manual (e.g. changes to the menus and/or functions), if we believe it necessary we will provide a new
operating manual for download at “www.kathrein.de”.
Make a note of the receiver's basic settings (these are set during rst installation), so you can restore them if necessary!
Included in the software for this receiver is software that is licensed under the GNU (General Public Licence). The source
code of the program is obtainable under: http://www.kathrein.de/linux/receiver/ufs922
The term DiSEqCTM used in this operating manual is a registered trade mark of the European Telecommunication
Satellite Organisation (EUTELSAT).
Switching the receiver off
Before you switch off the receiver using the power switch, you must switch the remote control into standby mode by
pressing the standby button (). In standby mode, any changed or new data that is broadcast will be saved by the
receiver. Once the receiver is in standby mode it can be fully switched off at any time at the power switch on the rear of
the unit.
Do not switch the receiver off at the power switch directly from operating mode! This can lead to a
loss of data and corruption of the software.
Miscellaneous
Important Information
Power consumption in standby mode < 1 W
The standby power consumption of < 1 W printed on the receiver packaging is only achieved when the receiver is in
standby mode with the display switched off. You can make the setting in the following menu: “Mainmenu”, “Settings”,
“User-dened settings”, “Customize screen menu”, “Front display in standby mode”