Filter
Top Products
17
206-4147
Channel Setup Options (Cont.)
Manual Tuning (Add/Delete Channels) / View Digital Signal Strength
Manual Tuning (Add/Delete Channels)
Use this option to manually add active channels or remove
unwanted channels. See also “Edit Channels” on the following
page.
1. Press MENU on the Installer Remote, and use the arrow
navigation keys to select/highlight the CHANNEL menu
option. Then, press ENTER.
2. Use the Up/Down arrows to select Manual Tuning, and then
press ENTER.
3. In the Manual Tuning pop-up window, use the Left/Right
arrows to select DIGITAL or ANALOG. Then, use the Up/
Down arrows to highlight the Channel fi eld.
4. In the Channel fi eld, use the Left/Right arrows to select the
required channel. Then, use the Up/Down arrows to select
Add or Delete (if the channel is not currently active, there
will be an “Add” button; otherwise, there will be a “Delete”
button as shown in the example at right).
5. Repeat steps 3 and 4 to add/delete additional channels.
6. When you are done adding/deleting channels, select Close
and press ENTER to close the pop-up window and return to
the Channel Menu.
7. Press MENU to return to TV viewing, or press RETURN to
return to the previous menu level.
View Digital Signal Strength
The Manual Tuning option described above enables you to
view the signal strength for digital inputs. Select the desired
digital channel in the Manual Tuning pop-up window to view the
quality of the digital signal being received.
CHANNEL
Enter
Move
Delete
Close
Select channel type and
RF channel number.
Channel 2
DIGITAL
►
►
DIGITAL 2-1
Bad Normal Good
Notes:
• A password is required to gain access to Manual
Tuning if the Lock System is turned ON.
• If you are/will be setting up this STB1000 as a
Master STB, complete any manual channel tuning/
editing BEFORE transferring the STB setup to the
internal STB controller (PTC). Refer to the Commer-
cial Mode Setup procedure on pages 40 to 41 for
further information.
• If you delete a found channel, it isn’t gone forever.
Simply re-add the channel to the channel lineup as
described in the “Edit Channels” procedure on the
following page.
Auto Tuning
Manual Tuning
Channel Edit
Channel Label