LG Electronics STB1000 Cable Box User Manual


 
58
206-4147
FTG Mode of Operation
FTG Con guration Overview
The following steps outline local FTG configuration of individual STB1000s. Since these models are
equipped with the EBL module, they can also be broadcast configured in FTG Mode by a Free-To-Guest
Management Appliance (FMA) head end device. Refer to the Free-To-Guest (FTG) Configuration
Application manual and/or the Installation & Setup manual for the FMA device for further information.
Note: FTG Configuration Application software is available online at: www.LGcommercial.com/
FTGsoftware.
1. Install (if necessary) and launch the FTG Configuration Application (v5.0.0 or higher) on the PC that
will be used to configure the EBL.
2. Build a Channel Map using the FTG Channel Map Editor in the FTG Channel Map Configuration
Utility (or, if applicable, open an existing FTG Configuration (.rml) file).
3. Connect the PC to the TV-LINK CFG jack on the STB1000 jack panel using a USB-to-TTL serial
cable (TTL-232R-5V-AJ). If necessary, install the device driver on the PC.
4. Turn ON the STB/display panel. Note: A green text banner that shows the EBL firmware version and
release date will briefly appear on the display panel.
5. “Write” the FTG Channel Map to the EBL (converts EBL from Pass-through Mode to FTG Mode).
6. “Read” the current FTG Installer Menu settings from the EBL using the FTG Installer Menu
Configuration Utility. If necessary to make changes to Installer Menu items, “Write” them back to the
EBL in FTG Mode.
7. Save the FTG Channel Map and FTG Installer Menu settings to an FTG Configuration (.rml) file for
future use.
8. Tune the STB1000 to a Logical Channel in the FTG Channel Map.
Laptop
PC
COMPONENT IN
VIDEO
AUDIO
R
L
UPDATE
RESET
AUDIO
(RGB/DVI)
PB
Y
P
R
.....
....
..........
2
1(DVI)
DIGITAL VIDEO IN
OPTICAL
DIGITAL
AUDIO OUT
REMOTE
CONTROL OUT
SPEAKER
OUT
8
RJP
INTERFACE
RGB IN
VIDEO
R-AUDIO-
L/MONO
AV IN 1
RGB(PC)
.....
.....
.....
TV-LINK
CFG
MPI/GAME
CONTROL
DISPLAY CONTROL
LAN
..........
STB1000
Jack Panel
USB-to-TTL Serial Cable
Required for local FTG
con guration.
TV-LINK CFG
Use for local FTG
configuration.