Filter
Top Products
66
206-4147
Reference: Upgrading STB Software using a USB Memory Device
Checking the Software Versions
Note: This function is not accessible while the
TV is in FTG or PPV Mode.
You can check the software versions of the STB
by accessing the Installer Menu with the
Installer Remote: Press MENU repeatedly until
the on-screen setup menus lock up, and then
press 9-8-7-6 + ENTER. When you are finished,
press ENTER again to exit the Installer Menu.
Typical Installer
Menu
CPU VersionPTC Version
epak : 3.31.0
lgres(RELEASE) : 3.31.0
ezcal(RELEASE) : 3.31.0
kernel(RELEASE) : 0.00.1
[ Current TV Software Version Information ]
epak : 3.0b.0
model(RELEASE) : 3.12.0
ezcal(RELEASE) : 3.0b.0
lgfont(RELEASE) : 3.12.0
TV Software Update
i
usb-03.00.00.FC
rootfs(RELEASE) : 0.00.1
emanual(RELEASE) : 0.00.1
kernel(RELEASE) : 3.12.0
micom(RELEASE) : 0.d0.b8
lgapp(RELEASE) : 3.31.0
model(RELEASE) : 3.31.0
boot(RELEASE) : 0.00.1
rootfs(REA/LEASE) : 0.00.1
The following software files are found in the memory card.
Upgrade PTC Software
i
PTC_STB1000_v1.00.000
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV
Upgrading TV/PTC Software
Before you begin, note that the software upgrade fi les must be stored in a
folder named “LG_DTV” in the root directory of the USB memory device.
Also, ensure the USB device has been formatted with FAT format.
Note for STB1000 Software Upgrade only: If the STB detects a later
version of software on the USB device, it will automatically display a dialog
from which you can start the software upgrade immediately. Otherwise, you
can close the dialog and access the USB Download Menu as described
below.
1. Turn ON the STB1000/display panel.
2.
Plug the USB memory device into the USB port on the STB rear panel.
3.
Press MENU on the Installer Remote to display the STB setup menus.
4. Use the arrow navigation keys to select/highlight either the Option (if
EBL is in Pass-through Mode) or Lock (if STB is in FTG or LodgeNet
PPV Mode) menu icon; then, press the number “7” key a total of seven
times to display the USB Download Menu.
5. Use the Up/Down arrow keys to select Upgrade TV Software or
Upgrade PTC Software, as applicable, and then press ENTER. (See
screen samples at right.)
6. Use the Up/Down arrow keys to select the upgrade to install, and then
press ENTER.
Update completion progress will be displayed on the screen in a new
window. Do NOT remove the USB device until the software upgrade is
complete. When a software upgrade is complete, the STB will reset itself
with an automatic restart. When a PTC upgrade is complete, the STB will
turn OFF.
LODGING PTC INSTALLER MENU
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC 20E7
PTC V1.00.00 STB V3.00.00