Filter
Top Products
12
SWITCHING ON
Remove the battery compartment cover from the back of the
Plaza HDR•S remote control by lifting the cover catch. Insert
the two AAA batteries supplied, as shown on the inside of the
compartment. Replace the compartment cover.
Turn on your TV set and choose the HDMI input (see your
television’s manual for guidance). Switch on the mains socket that
the Plaza HDR•S is connected to.
After a few seconds, the receiver’s fi rst Freesat installation screen
will appear on the television screen:
TUNING IN
When the fi rst installation screen is displayed, use the or buttons
to select between 16:9 Widescreen or the squarer 4:3 Traditional
as the screen format of your television. Then press the button
or the button to highlight the HDMI Resolution selection box,
and use the or buttons to select the correct resolution for your
television. You should set the HDMI resolution to the highest that
your television can display (see your television’s manual). If in doubt,
set the resolution to 720p.
HINT: If you do not see this screen on your television, see
‘Troubleshooting’ on page 44.
Cover catch