M-Audio 52803 DVR User Manual


 
of your choice, send program change data from the keyboard, select the
MIDI transmit channel of the M-Audio Ozone, set the octave or pitch of
the keyboard, and program the eight rotary controllers.
DATA ENTRY Assignments: Pressing the MIDI/SELECT button then
pressing a key labeled by its MIDI function (such as velocity offset,aftertouch,
reverb depth, pan pot, volume, CC data) and then moving the data entry
slider, allows you to select the transmitting value of the chosen function.
For example, if you want to change the value of the velocity offset, first
press the MIDI/SELECT button and then the velocity key. Second, change
the data entry slider to the value you want.Finally, press the MIDI/SELECT
button again to finish the change.
To assign any MIDI control value to the data slider:
1. Press the MIDI/Select button
2. Press the CC No. key (low B)
3. Press the number keys to choose the MIDI controller number
4. Press the Enter key
5. Press the MIDI/Select button to finish your selection.
For a chart of MIDI control change values, see Appendix A in this manual.
You can also use the data slider to send this MIDI controller information
in real time. When the M-Audio Ozone powers up, the DATA ENTRY
slider defaults to a MIDI controller value of 7.A Controller 7 message is
the equivalent of a MIDI volume message. Once you’ve selected one of the
keys that represents a controller value, i.e., velocity, aftertouch, pan pot,
etc., or assigned a value using the number keys,the DATA ENTRY key then
takes on that value and will transmit that type of controller information
when the slider is moved
SET CTRL Key: Pressing the MIDI/SELECT button and then the SET
CTRL key will allow you to begin programming the rotary control knobs.
In order to change the value of each knob (1 - 8),you need to do as follows:
1. Press MIDI/SELECT, then the Set Controller key, F3 (marked “SET
CTRL.)” The display will show a small “n” to indicate that the desired
controller knob “number” should be entered next.
2. Choose the number of the desired controller knob using the number
key group (1 - 8).Then press the Enter key.The display will show a “P”
in anticipation of the “parameter” number.
3. Assign the desired MIDI controller parameter number using the
number key group (1-127),then press Enter.The display will show a “C”
in anticipation of the MIDI “channel” number. See chart,“Appendix A.”
41