M-Audio 52803 DVR User Manual


 
4. Assign the MIDI channel number on number key group (1-16) then
press Enter.This channel assignment will apply only to the controller
knob that you are programming.
5. You can select up to five banks of presets for the M-Audio Ozone’s
keyboard, P1-P5, by pressing the MIDI/SELECT button. This is most
effective for stand-alone mode, not for all soft-synth presets.
6. Finally, Press MIDI/SELECT key again to finish assigning values to the
controller knob.
RESET Key: Pressing the MIDI/SELECT button, followed by the RESET
key and then the Enter key, will send out a message to return all external
MIDI instruments to their default setting. Press the MIDI/SELECT button
again to complete the process.
Flat and Sharp Keys: By pressing the MIDI/SELECT button and the flat
or the sharp key, you will shift the active keyboard pitch one note (half-
step) higher,or lower. For example,if you want to change the pitch 2 notes
down, press MIDI/SELECT button and the flat key twice. Press the
MIDI/SELECT button to finish the change.
To change the M-Audio Ozone’s octave range, press the the “Octave Up”
or “Octave Down” button however many times you wish to shift the
octave range. Press the MIDI/SELECT button to finish the change.
MIDI CHANNEL Select: Pressing the MIDI/SELECT button and then
pressing the MIDI CHANNEL key allows you to select the transmitting
channel for your keyboard.The default Channel is 1 when the keyboard’s
power is turned on.To set the MIDI channel to 2, for example:
1. Press the MIDI/SELECT button.
2. Press the key labeled “MIDI CHANNEL,” on the keyboard.
3. Press the key labeled 2, on the keyboard, then press the key labeled
“Enter,” also on the keyboard.Lastly,press the MIDI/SELECT button one
more time (this will change the MIDI transmit channel from 1 to 2.)
Control Change Data Entry by Numeric Keypad: M-Audio Ozone
allows you to use the numeric keys, instead of the data entry slider, to
specify the Control Change parameter data.This is done by pressing the
MIDI/SELECT button, CC (No. or Data) key, required number key(s), and
the Enter key.As an example, to assign a Control Change value of 7, and
CC Data value of 123:
1. Press the MIDI/SELECT button.
2. Press the CC No. key.
3. Press the key labeled 7.
4. Press the Enter key, in order to specify the Control Change as 7.
42