Filter
Top Products
18
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
AUTO SET UP / Initial settings
/ Initial settings
AUTO SET UP (continued)
The <RECORD SETTING> screen consists of 2
pages. The second page is displayed when turning the
JOG dial to move the cursor to “NEXT PAGE”, and turn
the SHUTTLE ring clockwise.
<RECORD SETTING> 1/2
Camera selection during alarm recording
<RECORD SETTING> ALARM CH
NO PPS GRADE A-PPS A-GRADE
>>
12.5P SUPER 12.5P SUPER
------ SUPER ------ SUPER
------ SUPER ------ SUPER
12.5P SUPER 12.5P SUPER
------ SUPER ------ SUPER
<ESTD REC> D H M
NEXT PAGE
4
5
1
2
3
<RECORD SETTING> 2/2
<RECORD SETTING>
NO PPS GRADE A-PPS A-GRADE
>>
------ SUPER ------ SUPER
12.5P SUPER 12.5P SUPER
------ SUPER ------ SUPER
------ SUPER ------ SUPER
<ESTD REC> D H M
PRESS POWER BUTTON TO EXIT
6
7
9
8
According to the number of the cameras connected
and the value of “RECORDING CYCLE”, the most suit-
able setting of the “PPS”, “A-PPS”, “GRADE” and “A-
GRADE” are set automatically.
12. When the setting is complete, press the POWER button.
• “SETTING UP...” is displayed on the screen, and the unit
starts-up.
To execute AUTO SET UP again, press and hold
the camera number button 1 and press the POWER
button, when the MAIN switch is set to ON and the
POWER button is set to OFF. The <CAMERA CHECK>
screen appears. However all menu of record setting
will be reset.
■ INITIALIZATION
The <INITIALIZATION> setting is used to select the mode of
peripheral recording devices connected to SCSI connector
ID4•ID5, to make HDD SETTING, and to initialize the HDD.
♦ HDD SETTING
The HDD SETTING can be set to MIRRORING (simulta-
neous recording to the internal HDD as a pair), PARTITION
(an independent partition that can be set within the total
HDD memory specifically for ALARM RECORDING). (
see pages 74,75 “MIRRORING”, “PARTITION”)
<INITIALIZATION>
>>
HDD SETTING NORMAL
POWER OFF
INITIALIZATION
ALL DATA WILL BE ERASED
WHEN PROCEED INITIALIZATION
♦ INITIALIZATION
Please perform initialization, when a <INITIALIZATION>
setup is changed.
1. Turn ON the MAIN switch on the rear of the unit, and wait
until the ACCESS indicator goes off. Hold down the REC/STOP
button, and press the POWER button on the front of the unit.
• The unit starts-up, and the <INITIALIZATION> screen is
appears.
POWER button operation will not be accepted while
the ACCESS indicator is flashing. Press the POWER
button after the indicator turns off.
2. Select “INITIALIZATION” by turning the JOG dial, and turn
the SHUTTLE ring clockwise.
• The setting is made, and the display returns to normal after
initialization.
Settings are not confirmed unless you perform
“INITIALIZATION”.
Performing “INITIALIZATION” initializes all data on
the HDD. It deletes the complete ALARM LIST, and
the next entry is registered from 00001.
Select “POWER OFF” to abort initialization.