Filter
Top Products
_Important:
_Important:
_Important:
TV + VCR + antenna or cable without a cable box
(cont.)
procedure
O Connect the incoming cable or antenna to the ANTENNA_IN
terminal on the VCR.
O Connect one end of a coaxial cable to the ANTENNA OUT
terminal on the VCR.
Connect the other end of the coaxial cable to the ANT-A termi-
nal on the TV.
O
Connect an RCA pin-type video cable to the VIDEO OUT
terminal on the back of the VCR. Connect the other end of this
cable to the VIDEO INPUT r_erminal on the back of the televi-
sion.
If you are connecting a Super VHS (S-VHS) VCR, use an S-Video
cable instead of an RCA pin-type video cable. Connect this S-Video
cable to the S-VIDEO OUT terminal on the VCR. Connect the
other end of this cable to the S-VIDEO INPUT terminal on the
back of the TV.
O
Connect a set of RCA pin-type audio cables, to the AUDIO OUT
terminals on the back of the VCR. Use the red cable to connect
the right (R) channel and the white cable for connecting the left
(L) channel.
Connect the other ends of this cable to tile AUDIO INPUT
terminals on the back of the TV.
If your VCR is monaural (non-stereo), you only need to connect a
single RCA pin-type audio cable. Connect the cable to the VCR,
then connect the other end to the L (LEFT) au,iio input on the back
of the TV.
If your VCR has a video channe! switch, set it to "OFF/AV". See
your VCR's owner's guide for details.
Start playing a tape on your VCR.
O Use the INPUT button on your TV's remote control to select the
correct input. If you connected the VCR tc, INPUT-l, select
Input-l; if you connected the VCR to INPUT-2, select Input-2.
30 Chapter 2: Connecting Your TV