Filter
Top Products
Using the remote control to operate VCRs, cable
boxes and other components (cont.)
using your remote control to operate your cable box
After you have set up your remote control for your particular brand
of cable box, you can use the remote to operate your cable box
O Use the select switch on the remote control to choose the layer
that you set up to operate your cable box: AUDIO or DVD.
O Point the remote control at the cable box and press the desired
buttons.
You can use the POWER, CHANNEL, numbers (0-9), and ENTER
buttons to operate your cable box. If you are using an RCA DSS or
PRIMESTAR ® receiver, you may be able to use additional buttons.
Refer to the instructions for these devices.
setting up the remote control to operate your Mitsubishi
disc player or A/V receiver
Turn off your audio component.
O Set the select switch on the top of the remote to choose the
layer you want to set up. For a laser disc player, choose AU-
DIO or DVD. For an A/V receiver, choose TV or AUDIO.
O While holding in the POWER button on the remote contro!,
enter one of these code numbers:
• For a Mitsubishi A/V receiver or a compact disc player: 30, 31,
35 or 38
• For a Mitsubishi and some Pioneer I_aserdisc playe_: 32 or 33
• For a Yamaha A/V receiver, compact disc player: 36 or 37
• For a Mitsubishi DVD player: 34
Be sure to enter both digits of the code number. If more than
one number is listed, try the first one.
O Release the POWER button.
O
Press the POWER button again. Your disc player or audio
component should turn on. If it does, your remote control is
now set up to operate your audio component. If it does not turn
on, repeat the instructions above, trying the other code number
listed for your component.
See Using" Your Remote Control to Operate Your Mitsubishi
Laserdisc Player and Using Your Remote Control to Operate
Your Mitsubishi A/V Receiver in this chapter for inff,rmation
on using the remote to operate your AA r components.
44 Chapter 3: Operating Your TV