Filter
Top Products
SQV
Important:
_Important:
Using SuperQuickView TM (cont.)
adding channels directly to the list with the remote
control's SQV button
0 Use the channel controls or number buttons to tune the !IV.to
the channel you want to add to the list.
O Press and hold the SQV buttcm for about 2 seconds. The letters
"SQV" will appear under the .channel number, indicating that
the channel has been added to SuperQuickView TM memory.
Once you've added a channel to the SQV memory, the letters "SQV"
appear under the channel number any time the channel number is
displayed, even if you tune to the channel in another manner.
If the SuperQuickView TM memory is full, the letters "SQV" will flash
when you hold the SQV button for about 2 seconds. Use the steps
below and on the preceding page to replace a current
SuperQuickView TM channel with a new channel or to remove exist-
ing SuperQuickView TM selections.
removing channels from the list with the remote control's
CANCEL button
O Use steps O - O from "customizing the SuperQuickView _ list
with the menus" on the preceding page to _elLectthe channel
position from the SuperQuickView TM list•
Press the CANCEL button on the remote control to clear the
entry. You can now add a SuperQuickView _ channel to the
blank entry.
Using the Advanced Features 83