Filter
Top Products
TV + VCR + cable with a cable box (cont.)
_>Important:
_>Important:
E>Important:
procedure
(See illustration on the following page.)
O Connect the incoming cable to the ANT-A terminal on the back
of the TV.
O Connect a coaxial cable from the cable LOOP-OUT terminal[ on
the back of the TV to the cable box IN terminal.
Connect a second coaxial cable from the OUT terminal on the
cable box. Connect the other end of this cable to the
ANTENNA-IN terminal on the back of tile VCR.
O Connect the third coaxial cable from the OUT terminal on tlhe
back of the VCR to the ANT-B terminal on the back of the _V.
O Connect an RCA pin-type video cable to the VIDEO OUT
terminal on the back of the VCR. Connect the other end. of this
cable to the VIDEO INPUT terminal on the back of the TV.
If you are connecting a Super VttS (S-VHS) VCR, use an S-Video
cable instead of an RCA pin-type video cable. Connect this S-Video
cable to the S-VIDEO OUT terminal on the VCR. Connect the
other end of this cable to the S-VIDEO INPUT terminal on the
back of the TV.
Connect a set of RCA pin-type audio cables to the AUDIO OUT
terminals on the back of the VCR. Use the red cable to connect
the right (R) channel and the white cable for connecting the left
(L) channel.
i
Connect the other ends of this cable to the AUDIO II_PUT
terminals on the back of the TV.
If your VCR is monaural (non-stereo): you will only need to c,onnect
a single RCA pin-type audio cable. Connect the cable to the audio
out terminal of the VCR, then connect the other end to the L
(LEFT) audio input on the back of the TV.
If your VCR has a video channel switch, set it to "OFF/AV'. See
your VCR's owner's guide for details.
Basic Connections 33