Filter
Top Products
10
Index to Parts and Controls
For operational instructions, refer to the page indicated in brackets.
■Front panel
1 (European and some Asian models only)
POWER switch [26]
Turns on the main power supply for the DVD Receiver. The DVD
Receiver enters standby state. Pressing the switch again to the off
position (— OFF) shuts down the main power supply into the DVD
Receiver.
Before turning on the power, make sure all cables are properly
connected.
2 STANDBY/ON button, STANDBY indicator [26, 37]
When STANDBY/ON button is pressed to ON (while the POWER
switch is set to ON on the European and some Asian models), the
DVD Receiver turns on. The STANDBY indicator turns off and the
display lights up. Pressing the button again returns the DVD
Receiver to the standby state. This state turns off the display,
disables control functions.
3 Disc tray [34]
When loading a disc, place discs in the disc tray with the label side
facing up.
4 0 button [34, 37]
Press to open and close the disc tray.
5 DISPLAY button [62, 63]
Press to change the information being displayed.
6 FM MODE button [38]
Press to switch the reception mode between stereo and monaural.
7 MASTER VOLUME control [42]
The MASTER VOLUME dial is used to control the volume level.
8 PHONES jack [42]
This is a standard stereo jack for connecting stereo headphones.
9 Display [11]
0 INPUT 5/∞ buttons [38, 39, 40]
Press to select the input source.
- 7 button [37]
Press to stop playback. Pressing once enables playback to resume
from a point shortly before the location where it was stopped.
Pressing twice causes the disc to return to the beginning of the
disc when playback starts again.
890-=~!#@$
%
^*&(
12 3 4 5 6 7
= £ button [34, 37]
Press to start or resume playback.
~ TUNING/PRESET 4/¢ buttons [36, 38, 39]
Press to go back or advance to previous chapters/tracks. Also, use
these buttons to change the tuner frequency.
! PRESET MEMORY button [38, 39]
Press to assign the radio station that is currently tuned in to a
preset channel or delete a previously preset station.
@ Front panel illumination
# SURROUND button [48]
Press to select a surround mode.
$ STEREO button [48]
Press to change the listening mode to “Stereo”.
% T-D button, indicator [47]
Press to activate Theater-Dimensional mode. T-D indicator
illuminates in Theater-Dimentional mode. T-D indicator goes off
when other mode is selected.
^ ACOUSTIC CONTROL button [50]
Press to change the acoustic mode to boost the super bass/high
frequency sounds.
& Remote control sensor [15]
Point the remote control toward the remote sensor to operate the
DVD Receiver.
* SUBWOOFER MODE button [31]
Press to select the subwoofer mode.
( (North American and South American model)
SPEAKER A/B button [29, 42]
Press to switch the speaker systems in use between A and B.
(Other models)
SPEAKER SETUP button [30]
Press to select the optimum speaker configuration.