Filter
Top Products
2929
Speaker Setup
(North American and South American model)
You need to set up the speaker configuration for the speaker system connected to the FRONT SPEAKERS A connectors (see this
page.) (There is no speaker configuration setup for the FRONT SPEAKERS B system.)
(Other then North American and South American models)
You need to set up the speaker configuration for the speaker system connected to the SPEAKERS connectors (see page 30.)
Notes
• Speaker setup cannot be done if;
– Headphones are connected (see page 43), or
– The FRONT SPEAKERS B system is On (North American and South American model only, see page 42).
• It is not necessary to set the parameters again once you have completed the setup unless you change the speaker configuration.
→
1
2
Press SPEAKER A/B to select
“Speaker A.”
Note
“Speaker B” also appears by pressing the
button repeatedly, though, this setting is
reserved for future applications. Therefore, be
sure to select “Speaker A.”
Press SP SETUP repeatedly to
select the number of channels for
the SPEAKERS A system.
Selecting the number of speaker channels (North American and South American model)
SP SETUP
Before operating the
remote controller
Press MODE AUDIO.
The remote controller
remains in the AUDIO mode,
until another MODE button is
pressed.
SPEAKER A/B
SPEAKER
A / B
Unit only
Remote controller
only
Pressing the button repeatedly within three
seconds changes the number of channels
as follows (the corresponding speaker
configuration is described in parentheses):
Speaker 5
ch
(Front left, center, and right,
plus surround left and right
speakers)
↓
Speaker 2
ch
(Front left and right speakers)
↓
Speaker 3ch
(Front left, center, and right
speakers)
↓
Speaker 4ch
(Front left and right, plus
surround left and right speakers)
The normal display resumes in three
seconds.
Speaker configuration indicator at the
upper left corner shows the current
speaker configuration.
Notes
• The listening mode will automatically be set to “Stereo” (see
page 48) once you set or reset the number of channels.
• To check the present setting while the normal display is
displayed, press SPEAKER SETUP once. To change the setting,
press the button repeatedly within three seconds.
Speaker configuration indicators indicate
current speaker configuration.
See following page for other than North American and South
American model.