Filter
Top Products
78
Controlling other components connected
to the DVD Receiver
The remote controller has two learning functions. One is
entering the signal number for a remote controller of another
brand that is pre-programmed. Another is a normal learning
function that enables the remote controller to learn the codes
from other remote controllers.
Caution
With some brand’s components, some buttons may not work
correctly. In this case, program the command separately.
Learning a pre-programming code
1
2
3
4
5
By learning a pre-programming code, you can make the
RC-484M remote controller able to operate a product from
another brand. The buttons that are used for operation are
given on the next page.
Find the 3-digit number for the
brand name of the component that
you want to operate in the table on
the next page.
Turn on the component that you
want to operate (i.e. DVD, satellite
tuner, or television).
While holding down the MODE
button on the RC-484M that you
want to program, press the +10
button, and then release both
buttons.
The SEND/LEARN indicator lights when
the MODE button is pressed and turns off
when the +10 button is pressed. Wait until
the indicator turns off before releasing both
buttons. Then the SEND/LEARN indicator
lights again.
Within 30 seconds, enter the 3-digit
code number.
The SEND/LEARN indicator flashes twice
slowly. If the SEND/LEARN indicator
quickly flashes three times, then either a
mistaken 3-digit code was entered or an
incorrect operation was performed. If this
occurs, return to step 3.
Press the button that you
programmed and check if the
system operates correctly.
• If the component does not operate
properly, return to step 3 and repeat the
steps above.
• If it still does not operate properly, then
program the commands one by one to
the buttons on the RC-484M remote
controller.