Filter
Top Products
43
→
Listening Through Headphones
Connect the plug of the stereo headphones to the
PHONES jack on the DVD Receiver.
Notes
• The speakers will not reproduce sound while headphones are
connected.
• The listening mode is set to “Stereo” after connecting the
headphones to the PHONES jack.
• When you disconnect the headphones, the listening mode returns
to the previous mode.
Controlling the Brightness of the
display on the DVD Receiver
Press DIMMER.
Each press of the button changes the
brightness as follows:
The display becomes less bright.
↓
The display is dimmed.
↓
The display is dimmed, and
the front
panel illumination goes off.
↓
The display resumes the original
brightness and
the front panel
illumination turns on.
Using the Sleep Timer
Press SLEEP.
“Sleep 90min” appears in the multipurpose
display for about 5 seconds, which means the
DVD Receiver will turn off and enter standby
mode in 90 minutes. Also the SLEEP
indicator is lit in the display while the sleep
timer is On.
Each press of the button makes the
remaining time shorter by 10 minutes.
Checking the remaining time
Press SLEEP while the Sleep Timer is On.
If you press SLEEP while the remaining time is displayed,
the remaining time is reduced by 10 minutes.
Canceling the Sleep Timer
Press SLEEP repeatedly until the SLEEP indicator goes
off.
Remote
controller only
Remote
controller only
VOL 5/∞
MUTING
SLEEP
DIMMER
PHONES jack
MASTER VOLUME
SPEAKER A/B
(North Ameri-
can and South
American
models only)