Filter
Top Products
49
CH SEL
TEST TONE
UP/DOWN 5/∞
21
Adjusting Each Speaker’s Relative Volume Balance Temporarily
You can readjust each speaker’s relative volume balance
according to your preference while listening to the sound.
The adjusted values will return to the values set on page 33
when the DVD Receiver enters standby mode, or the main
power is switched off unless you save the values.
Remote controller
only
Remote controller
only
Saving the adjusted values
Press TEST TONE.
(Adjusting each speaker’s relative
volume balance)
Press CH SEL repeatedly to select
the speaker, then press UP/DOWN
5/∞ to adjust the volume level.
The volume level can be adjusted
between –12dB and +12dB.
Repeat this step to change another
speaker’s volume balance.
(Checking each speaker’s relative
volume balance)
While playing the source, press CH
SEL repeatedly.
Each press of the button changes the
speaker which outputs the sound and the
selected speaker appears in the display in
the following order:
Left (Front left ch.)
↓
Center (Center ch.)
↓
Right (Front right ch.)
↓
Surr R (Surround right ch.)
↓
Surr L (Surround left ch.)
↓
Subwfr (Subwoofer)
↓
Speaker volume adjustment mode off
Note
Any speaker that is not included in the speaker
configuration on pages 29-31 is not selected
even if it is actually connected.
Press MODE AUDIO first.