Onkyo DR-S501 DVD Player User Manual


 
11
Before Using the DVD receiver
Notes:
If the remote controller doesn’t work reliably, try
replacing both batteries.
Don’t mix new and old batteries, or different types of
batteries.
If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage
and corrosion.
Flat batteries should be removed as soon as possible to
prevent possible leakage and corrosion.
To use the remote controller, point it at the DVD
receiver’s remote control sensor, as shown below.
Notes:
The remote controller may not work reliably if the
DVD receiver is subjected to bright light, such as
direct sunlight or inverter-type fluorescent lights.
Keep this in mind when installing the DVD receiver.
If another remote controller of the same type is used in
the same room, or the DVD receiver is installed close
to equipment that uses infrared rays, the remote con-
troller may not work reliably.
Don’t put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
The remote controller may not work reliably if the
DVD receiver is installed in a rack behind colored
glass doors. Keep this in mind when installing the
DVD receiver.
The remote controller will not work if there’s an
obstacle between it and the DVD receiver’s remote
control sensor.
Installing the Batteries
1
To open the battery compartment, press
the small hollow and slide off the cover.
2
Insert the two supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.
3
Put the cover onto the remote controller
and slide it shut.
Using the Remote Controller
Remote control sensor
DVD receiver
Approx. 5 m