Filter
Top Products
57
Configuring the DVD receiver—Continued
Crossover Frequency
This setting only applies to the speakers that you speci-
fied as “Small” in the “Front Speakers Size” on page 56.
To get the best bass performance from your speaker sys-
tem, you need to set the crossover frequency according
to the size and frequency response of your speakers.
Use the diameter of the smallest speaker in your system
when choosing the crossover frequency.
*Choose the setting suitable for the speaker.
Notes:
• For a more accurate setting, look up the frequency
response in the manuals supplied with your speakers
and set accordingly.
• Choose a higher crossover frequency if you want more
sound from your subwoofer.
• When a DVD-Audio or an SACD is played in the Ste-
reo listening mode, no effect will be produced.
• When the listening mode is set to Direct, or Pure
Audio, no effect will be produced.
AM Frequency Step Setup
(not European models)
You must specify the AM frequency step used in your
area. Note that when this setting is changed, all radio
presets are deleted.
10 kHz: Select if 10 kHz steps are used in your area.
9kHz: Select if 9 kHz steps are used in your area.
Audio Input Setup
If you connect a component to a digital input jack, you
must assign that jack to an input. For example, if you
connect your DVD recorder to the COAXIAL DIGITAL
AUDIO IN jack, you should assign that jack to the
“Video 1 input”. By default, the COAXIAL DIGITAL
AUDIO IN jack is assigned to the “Video 2 input”,
although this can be changed.
Here are the default assignments.
OPT: optical digital audio input
Coax: coaxial digital audio input
ANA: analog audio input
Note:
The same audio input cannot be simultaneously assigned
to both VIDEO 1 INPUT and VIDEO 2/DOCK INPUT.
Digital Input Signal Formats
The digital input signal formats are available only for the
input sources that you have assigned a digital input jack
(see above).
Normally, the DVD receiver detects the signal format
automatically. However, if you experience either of the
following issues when playing PCM or DTS material,
you can manually set the signal format to PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try setting the format to PCM.
• If noise is produced when fast forwarding or reversing
a DTS CD, try setting the format to DTS.
DTS or PCM: The DTS or PCM indicator, depending
on which format you have set, flashes, and only signals
in that format are output. Digital signals in other formats
are ignored.
Auto (default): The format is detected automatically. If
no digital input signal is present, the corresponding ana-
log input is used instead.
Speaker cone diameter Crossover frequency
Over 20 cm 40/50/60 Hz*
16–20 cm 80 Hz
13–16 cm 100 Hz(default)
9–13 cm 120 Hz
9 cm 150/200 Hz*
Input Default assignment
VIDEO 1 INPUT OPT
VIDEO 2/DOCK INPUT Coax