Filter
Top Products
53
Controlling Other Components
You can control a TV. You must enter the appropriate
remote control code first.
Entering Remote Control Codes
Note:
The remote control codes provided are correct at the time
of printing, but are subject to change.
Controlling a TV
To control a TV, point the remote controller at it and use
the buttons explained below. With some TVs, certain
buttons may not work as expected, and some may not
work at all.
TV [ ]
Sets the TV to Standby or On.
TV [INPUT]
Selects the TV’s AV input.
TV VOL [ ]/[ ]
Adjusts the TV’s volume.
TV [CH +/–]
Selects channels on the TV.
Controlling a TV connected to the
DVD receiver
1
Look up the appropriate remote
control code in the “Remote Con-
trol Codes list” at the end of this
manual.
2
HOLD
HOLD
Hold down the TV [ ] and
[ENTER] buttons for about 3 sec-
onds.
3
Within 30 seconds, use the num-
ber buttons to enter the 4-digit
remote control code.
ENTER
TV
Number
buttons
4
Point the remote controller at the
TV, and check the operation.
If the remote controller doesn’t work as
expected, and several remote codes are
listed, try each one in turn and use the
one that works best.