Filter
Top Products
39
Listening to the Radio
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets
for quick selection.
Listening to the Radio
Tuning into Radio Stations
■ Auto Tuning Mode
When tuned into a station, the indicator appears.
When tuned into a stereo FM station, the FM ST indica-
tor appears on the display, as shown.
Note:
This procedure can also be performed on the DVD
receiver by using its TUNING/PRESET [ ]/[ ] button.
Press the TUNING/PRESET [ ]/[ ] button to start
searching for a few seconds. Pressing the TUNING/
PRESET [ ]/[ ] button again stops the searching.
After this, press the button repeatedly to change the fre-
quency one step at a time.
■ Manual Tuning Mode
Radio Frequency can be changed in 0.05 MHz steps for
FM and 9 kHz steps for AM. You can change the interval
of the steps for AM frequency (not European models)
(see page 55).
In Manual Tuning mode, FM stations will be in mono.
Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Using the Tuner
Use the INPUT [ ]/[ ] button to
select either AM or FM.
In this example, FM has been selected.
(Actual display depends on country)
TUNING
/
DISPLAY
SEARCH
MEMORY
CLR
INPUT /
MODE
PRESET /
Number
buttons
Band Frequency
1
Press the [MODE] button so that
the AUTO indicator appears on
the display.
2
Press the TUNING [ ]/[ ] button.
Searching stops when a station is
found.
To stop searching, press Stop [ ] but-
ton.
1
Press the [MODE] button so that
the AUTO indicator disappears
from the display.
2
HOLD
Press and hold the TUNING [ ]/
[] button.
The frequency stops changing when
you release the button.
Press the buttons repeatedly to change
the frequency one step at a time.
AUTO FM ST
FM STAUTO