Filter
Top Products
13
Getting to Know the DV-CP802—Continued
J Play indicator (25)
This indicator is shown during playback.
K Pause indicator (25)
This indicator appears when playback is paused.
L
Title & group number
Title and group numbers appear here.
M Chapter & track number
Chapter and track numbers appear here.
N Time display
Time information, such as total time, remaining
time, and so on, is displayed here in hours, minutes,
and seconds. Other messages are also displayed.
O MP3 indicator
This indicator appears while an MP3 track is being
played.
P Dolby Digital ( D), Dolby Pro Logic
( PL) & DTS ( ) indicators
The Dolby Digital indicator ( D) appears when
a Dolby Digital soundtrack is selected. The Dolby
Pro Logic ( PL) indicator appears when the
DV-CP802’s Dolby Pro Logic decoder is on. The
DTS indicator appears when a DTS soundtrack is
selected.
Q DISC indicators 1–6 (23)
These indicators show how many discs are loaded.
When the disc tray is closed, all of the disc indica-
tors appear until the DV-CP802 has checked each
bay for the presence of a disc. If a bay is found to
have no disc, the corresponding indicator disap-
pears.
For detailed information, refer to the pages in parenthe-
sis.
A VIDEO OUTPUT (18)
This socket outputs composite video and can be
connected to a composite video input on a TV or
projector.
B S VIDEO OUTPUT (18)
This socket outputs S-Video and can be connected
to an S-Video input on a TV or projector.
C COMPONENT VIDEO OUTPUT (18)
These sockets output component video and can be
connected to a component video input on a TV or
projector.
D FRONT/D.MIX 1 & 2, SURR 1, CENTER &
SUBWOOFER AUDIO OUTPUT (19)
These sockets output 5.1-channel analog audio and
can be connected to a 5.1-channel analog audio
input on an AV receiver, surround sound decoder
(Dolby Pro Logic), or other component. The
FRONT/D.MIX 1 & 2 outputs can be used as either
front outputs or downmix outputs (see page 52).
E SURR 2 AUDIO OUTPUT (19)
These sockets output the same analog audio as the
SURR1 outputs and can be connected to the analog
surround back left and right inputs on a 7.1-channel
AV receiver or other component. When using these
sockets, the SURR MODE switch should be set to
1+2.
F SURR MODE (AUDIO OUT) switch (19)
This switch is used to set the surround output mode
of the analog multichannel audio outputs. If you
connect the SURR 2 outputs to a 7.1-channel AV
receiver or amp, set this switch to 1+2. This reduces
the output level by 3 dB. If you’re not using the
SURR 2 outputs, set it to 1.
Rear Panel
L
R
89 J
2317654