Filter
Top Products
41
● HTTP Port (HTTP PORT)
Set an HTTP port number.
The default is 80.
Available port numbers: From 00000 to 65535, except
the "well-known port" numbers assigned by IANA
(Internet Assigned Numbers Authority)
● Dynamic Host Configuration Protocol
(DHCP)
Dynamic Host Configuration Protocol is enabled or dis-
abled.
The default is OFF.
Note: When ON is selected, you cannot enter the IP
address, netmask, or gateway. The host gives these
parameters.
The given parameters will be displayed after getting
the IP address from the DHCP server.
● IP Address (IP ADDR)
The default is "192.168.000.010".
● Netmask (NETMASK)
The default is "255.255.255.000".
● Gateway (GATEWAY)
The default is "192.168.000.001".
■ Switcher Setup (SWITCHER
SETUP)
Video switcher functions are programmed in this menu
setup.
● Start Display (START DISPLAY)
The image in the selected form will be displayed on the
multiscreen monitor and spot monitor when the recorder is
turned on.
The default is QUAD-4A for MULTI OUT and 1 for SPOT
OUT.
Single image: CH 1 to CH 8*
Quad image: QUAD-4A (including 1-4), QUAD-4B
(including 5-8)
Multi image: 9SCREEN (including 1-8)
Sequence: SPOT SEQ*, MULTI SEQ
Note: The spot monitor can display only CH 1-8* and
SPOT SEQ* while the multiscreen monitor can dis-
play all forms listed above.
● Multiscreen Selection (MULTI SEL
MODE)
When pressing the [MULTI SCREEN SEL] button on the
front panel, the monitor display will change as follows
depending on the setup.
QUAD ONLY: QUAD-4A → QUAD-4B → QUAD-4A
ALL: QUAD-4A → QUAD-4B → 9SCREEN → QUAD-4A
● Sequence Setup (SEQUENCE
SETUP)
1. Move the cursor to SEQ SETUP in the SWITCHER
SETUP menu, and press the JogDial.
The SEQUENCE SETUP menu opens.
2. Select either MULTI SEQ SETUP or SPOT SEQ SETUP
with the [D] or [C] button, and press the JogDial. The
selected menu opens.
SWITCHER SETUP
START DISPLAY
MULTI OUT QUAD-4A
SPOT OUT 1CH
MULTI SEL MODE ALL
SEQUENCE SETUPO
CAMERA VIEW SETUPO
SECRET VIEW OFF
SEQUENCE SETUP
MULTI SEQ SETUPO
SEQUENCE TIMING INT
AUTO SKIP ON
SPOT SEQ SETUPO
SEQUENCE TIMING INT
AUTO SKIP ON