Filter
Top Products
26
RQT9058
Preparation:
Turn on the unit and connected equipment.
[RAM] If the disc is protected, release protection
( 47).
[VHS] Ensure accidental erasure tab is intact.
When recording multilingual broadcasts ( 21)
DRIVE
SELECT
to select the drive (DVD or
VHS).
Insert a disc or VHS cassette.
REC MODE
to select the recording
mode ( 22).
INPUT SELECT
IN1
IN2
DV
OK
Input Select
1
2
3
Recording from an External Device
Connect cables while the power to both the unit and the
external device is off.
Front of the unit
S VIDEO
IN 2
VIDEO
/MONO
AUDIO
R
L
You can get a
sharper, clearer
picture by connecting
with an S Video cable
instead of the yellow
video cable.
Yellow White Red
S Video cable
Audio/video
cable
[RAM] [-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW]
Perform steps 1−5 left.
Start play on an external device.
REC
to start recording the
program from an external device.
PAUSE
to start recording the
program from the external device.
Perform steps 1−5 left.
PLAY
to locate the point on the
tape where you want to insert the
recording.
PAUSE
when you reach that point.
REC
to put the unit in recording
standby.
Start play on the external device.
Recording to VHS
Recording to DVD
Tips
To skip unwanted parts
Press [ PAUSE] to pause recording. (Press again to restart
recording.)
To stop recording
Press [ STOP].
, to select “IN1” or “IN2”,
then
OK
–
If a program is recorded from a set top box
equipped with a Hard Drive, etc., connected to
IN1 on the rear, then select “IN1”.
– Front Panel inputs are IN2.
Notes
If video is copied from another piece of equipment to this unit, then
the video quality will be degraded.
Recording from a VCR or a Set top box
equipped with a Hard Drive,etc.
Tips
If the external equipment only has a single audio output, connect it
to the L/MONO (white) IN2 terminal.