Filter
Top Products
RQT8320
23
Recording from a satellite/digital terrestrial receiver
Preparation
• Insert a disc (Ô page 18).
• When recording a bilingual programme (Ô page 16).
Preparation
• Connect a satellite/digital terrestrial receiver to this unit’s
input terminals (Ô page 9).
• When the output signal from the external equipment is
NTSC, change the “TV System” to “NTSC” in the Setup
menu (Ô page 43).
1 While stopped
Press [INPUT SELECT] to select the
input channel for the equipment you
have connected.
e.g.,
If you have connected to the AV2 input terminals,
select “AV2”.
2 Press [REC MODE] to select the
recording mode.
3 Select the channel on the other
equipment.
4 Press [* REC].
Recording starts.
To skip unwanted parts
Press [h] to pause recording. (Press again to restart
recording.)
To stop recording
Press [g].
To record programmes from a SKY Digital STB/digital
terrestrial receiver using timer programming
Preparation
• Make sure you connect the AV2 input terminal of this unit to
“VCR Scart Terminal” of a SKY Digital STB/digital terrestrial
receiver with a 21-pin scart lead (Ô page 9).
• Set the “AV2 Input” and “Ext Link” to match the connected
equipment in the Setup menu (Ô page 41).
1 Make timer programming on SKY
Digital STB/digital terrestrial receiver.
2 Press [EXT LINK].
The unit turns off and “EXT-L” lights on the unit’s
display to indicate timer recording standby has been
activated.
To cancel the external control
Press [EXT LINK] to stop recording or to cancel linked timer
recording standby.
• In order to prevent accidental operation, press [EXT LINK]
to cancel the setting after recording is finished.
For your reference
• This function does not work with some equipment. Refer to
the equipment’s operating instructions.
• The beginnings of recordings may not be recorded correctly
in some cases.
• When “Ext Link” is set to “Ext Link 2”, this function does not
work if the input signal is NTSC system.
• Programmes are recorded as one title on this unit when the
end time of the earlier timer recording and the start time of
the later timer recording are close to each other.
To divide the titles, go to “Divide Title” (Ô page 31).
• While the unit is in EXT LINK standby mode or recording,
video picture is from the AV2 input terminal irrespective of
“AV1 Output” setting.
Manual Recording
g
EXT LINK
CH
EXT LINK
AV3
DV IN
gEXT LINK
* REC
REC MODE
INPUT
SELECT
h
* REC
RAM -R -R DL -RW(V) +R +R DL +RW
Linked timer recordings with
external equipment (SKY Digital
STB/digital terrestrial receiver)–
EXT LINK
RAM
Timer recording/Recording from a satellite/digital terrestrial receiver