Filter
Top Products
32 Pelco Manual C681M-D (2/02)
5. Do one of the following:
•Turn the JOG dial to go to another item in this menu.
•Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-
other menu.
• Press the SET UP button to exit the programming mode.
FIFO/OVERWRITE MODE (DX3016 Models Only)
Use this setting when you want to make repeated backups to a hard disk drive that is con-
nected to ID4.
Skip steps 1 and 2 if they have already been done.
1. Press the SET UP button to display the Menu Setting menu.
2. Turn the JOG dial to move the cursor to INITIAL SET UP, and then turn the SHUTTLE
ring to the right. The Initial Set Up menu appears.
3. Turn the JOG dial until the cursor is next to FIFO/OVERWRITE MODE, and then turn
the SHUTTLE ring to the right. The option starts flashing.
4. Turn the JOG dial to select ON or OFF, and then turn the SHUTTLE ring to the right.
The option stops flashing.
5. Do one of the following:
Turn the JOG dial to go to another item in this menu.
Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to another
menu.
Press the SET UP button to exit the programming mode.
BACKUP FOLLOWING A POWER FAILURE
If a power failure occurs during backup, the backup process must be started over.
Press the ARCHIVE button to restart the backup process if the recorder is not set for timer
recording or if the current time is not covered by a timer program.
If the recorder is set for timer recording and the current time is covered by a program,
backup restarts automatically after power is restored.
When the backup process is restarted, all data backed up until the power failure is lost, and
the backup pointer returns to the backup starting point before the power failure.
NOTE:
This menu item
does not appear unless a
hard disk drive is connected
to ID4.