Filter
Top Products
Pelco Manual C681M-D (2/02) 63
Still-Frame Playback Mode
1. Press the PAUSE button while the recorder is in playback or reverse playback. The
unit shifts to still-frame playback mode.
2. Turn the SHUTTLE ring to the desired playback speed.
3. The unit shifts to still-frame playback mode when the SHUTTLE ring is returned to the
center position.
Shuttle Hold
Pressing the PAUSE button during playback (or reverse playback) shifts the recorder into still-
frame mode. Rotate the SHUTTLE ring to the desired search speed, and then press the
PAUSE button while holding the SHUTTLE ring at the selected search speed. Search speed
will be maintained even when the SHUTTLE ring is returned to its original position.
CHANGING PLAYBACK INTERVAL
When the PLAY or REV PLAY button is pressed when the unit is not in operation, playback
occurs at the same intervals as the recording intervals. Playback intervals can be changed,
however, when the PLAY or REV PLAY button is pressed while the unit is in playback or re-
verse playback operation. This is a convenient function for slow viewing of recordings with
fast movement or fast playback of images captured at long recording intervals.
Playback or reverse playback intervals speed up when the PLAY button is pressed.
Playback or reverse playback intervals slow down when the REV PLAY button is pressed.
If the time and date display is in Mode 2 or 3 (refer to
Time and Date Display
in the
Pro-
gramming
section), you can verify the change by observing the playback interval (number
followed by an F) in the display.
An audio recording cannot be played when the playback interval has been altered, even if
the playback interval is returned to its original rate. To play back an audio recording, stop
playback and restart it at the original rate.
FAST FORWARD/REWIND
When the SHUTTLE ring is turned clockwise or counterclockwise for more than one second
when the recorder is not recording, the unit shifts into high-speed fast-forward or high-
speed rewind mode, and an indicator appears at the bottom left of the monitor. “S” denotes
the start point of the data stored in the hard disk and “E” denotes the end point. The vertical
line marks the current position.
Press the STOP button to stop the fast forward or rewind operation.
SEARCHING
Time and Date Search
1. Press the SEARCH button to display the Search Selection menu.
2. Make sure the cursor is next to SELECTION CAMERA NO., and then turn the
SHUTTLE ring to the right. The option starts flashing.
3. Turn the JOG dial to select the option, and then turn the SHUTTLE ring to the right.
The option stops flashing.
Turning the JOG dial switches the options as follows:
DX3009 Models – ALL, 1, 2, 3, 4, 5, 6, 7, 8, 9
DX3016 Models – ALL, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16
01-01-2000 SAT A0001
00 : 00 : 00 15F 30%
SE