Filter
Top Products
54 Pelco Manual C681M-D (2/02)
16. Turn the SHUTTLE ring to the left to return to the Timer Program menu. Repeat steps
3-15 to define other patterns.
17. When you finish defining patterns, do one of the following:
• Proceed to the next section (
Motion Detection During a Timer Recording
) to set
up motion detection to operate during a timer recording (DX3016 models only).
•Turn the SHUTTLE ring to the left twice to return to the Menu Setting menu to go
to another menu.
• Press the SET UP button to exit the programming mode.
When timer settings overlap, the unit will give priority to the higher-numbered program.
Example 1
• Program 1 is set for 14:00 to 17:00 with a recording interval of 3F.
• Program 2 is set for 15:00 to 16:00 with recording interval of 5F.
Under this condition, the unit will give priority to Program 2 for the duration of the over-
lapping period, from 15:00 to 16:00. The unit will operate as shown in the illustration
below.
Example 2
• Program 1 is set for 14:00 to 17:00 with a recording interval of 3F.
• Program 2 is set for 15:00 to 16:00 with the SKIP setting.
Again, the unit will give priority to Program 2 for the duration of the overlapping period.
As shown in the illustration below, the unit will activate the Skip setting from 15:00 to
16:00.
Example 1)
In Program #1, recording is set for every
3F, from 14:00 to 17:00.
14:00 15:00 16:00 17:00
14:00 15:00 16:00 17:00
5F
In Program #2, recording is set for
every 5F, from 15:00 to 16:00.
Actual recording will occur as follows.
3F 3F
Setting for the prioritized Program #2.
In this situation, the unit gives priority to the higher-numbered Program #2.
3F
5F
Example 2)
In Program #1, recording is set for
every 3F, from 14:00 to 17:00.
14:00 15:00 16:00 17:00
14:00 15:00 16:00 17:00
SKIP
In Program #2, the SKIP setting is
entered for 15:00 to 16:00.
3F
3F
3F
NO
RECORDING!
Actual recording
Setting for the prioritized Program #2.
In this situation, the unit gives priority to the higher-numbered Program #2.